Wireless Burglar Alarm System Infrared Remote Control Alarm

remote control sensor alarm,alarm with remote contorl will be more convenient for using,wide range and far distance

Specifications

Wireless Burglar Alarm System Infrared Remote Control Alarm
1 Mini shape
2.120db loudly
3.Simple to operate & easy to inset

Wireless Burglar Alarm System Infrared Remote Control Alarm
1 Mini shape
2.120db loudly
3.Simple to operate & easy to inset

Technical parameters:
1. Power: DC 6V (4 5 # batteries)
2. Alarm sound loudness: within 1 meter of not less than 120db
3. Infrared detection range :1-8 m, about 110 degrees

 

Installation requirements:
 1. Infrared remote control alarm because the body lateral movement relative to the lens infrared detection highest sensitivity, while the vertical motion sensitivity poor, so installation should pay attention to the angle between the horizontal and height detectors, which have great impact on the protected area.
 2. alarm installation should be avoided near the heat source, such as hot and cold air outlet, air vent, heater, air cooler, etc., to avoid the straight on the doors and windows.
 3. Infrared remote control alarm on the scope of protection should be able to look directly, can not have obstacles.Infrared remote control alarm into the wall should be 10 to 30 degrees angle, then detection distances, the actual installation to adjust the installation according to the angle.

 

Installation:
 1. The universal seat fixed in the ground 2 meters away from the place.
 2. Open the battery cover, inside the battery compartment in accordance with the identity of the four load cells 5.
 3. Infrared remote control alarm will be fixed in the universal seat, turn alarm, to meet the installation requirements and needs can be detected.

 

Usage:
 1. Press the remote control switch, turn indicator light about that white check normal.
 2. Infrared remote control alarm, after the just-machine is not detected within 20 seconds alarm signal, you must leave within 20 seconds in which alarm detection area.
 3. 20 seconds after the entry into alarm if the detection area, remote control infrared alarm will issue a piercing alarm sounds for 30 seconds. 5 seconds after the alarm sounds, if there are personnel touch infrared remote control alarm, it will alarm again, again and again.
 4. Infrared remote control alarm in the alarm, you can turn off the remote control to end the alarm